20ft Serpentine Trade Show Display Booth

20 Ft Serpentine Trade Show Display Booth with Curved Panels & One Continuous Display

Instead of a flat wall, this booth uses a serpentine layout- three panels that curve and connect to create movement across the whole space. Your graphics wrap around the curves naturally, so the design reads one continuous piece rather than three separate sections stitched together. For exhibitors who want their booth to actually catch someone's eye from across the hall, this shape does a lot of work for you.

Underneath the fabric, the frame is built from 32 mm aluminum tubing, strong enough to hold its shape through repeated setup and teardown, but still light enough that one or two people can pack it up and move it without much hassle. The graphic fits over the frame like a fitted sheet, pulling tight as it goes on, so you're left with a clean, wrinkle-free surface once it's in place. The graphics themselves are dye-sublimation printed on 6.7 oz polyester fabric, which keeps colors accurate and consistent across the full width of the display- no faded patches or mismatched tones between panels.

When the show wraps, the whole thing collapses into sections small enough to fit in the included carry bag, so getting it to your car or shipping it to the next venue isn't a project on its own. As for upkeep, the fabric graphic can go in the washing machine on cold, a mild detergent is fine, and it tumble dries on low. Just make sure it's fully dry before folding it away for storage. With a bit of basic care, it'll hold up through a full season of shows without needing to be replaced. Order today!